Siemens SINUMERIK 802D sl Programming And Operating Manual page 60

Programming
3.2 Positional data
Figure 3-9
Notes
● For G25, G26, the channel axis identifier consisting of MD 20080
● G25, G26 is also used in connection with the address S for the spindle speed limitation.
● A working area limitation can only be activated if the reference point for the relevant axes
Programming example
N10 G25 X0 Z40
N20 G26 X80 Z160
N30 T1
N40 G0 X70 Z150
N50 WALIMON
...
N90 WALIMOF
3-30
Programmable working-area limitation
AXCONF_CHANAX_NAME_TAB is to be used.
With SINUMERIK 802D sl, kinematic transformations (TRAANG) are possible. In some
cases, different axis identifiers are configured for MD 20080 and for the geometry axis
identifiers MD 20060: AXCONF_GEOAX_NAME_TAB.
has been approached.
; Values of the lower working area limitation
; Values of the upper working area limitation
; Working area limitation ON
; Work only within the working area
; Working area limitation OFF
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding