Circular Interpolation Via Intermediate Point: Cip - Siemens SINUMERIK 802D sl Programming And Operating Manual

3.3.4

Circular interpolation via intermediate point: CIP

Functionality
The direction of the circle results here from the position of the intermediate point (between
starting and end points). Specification of intermediate point: I1=... for the X axis, K1=... for
the Z axis.
CIP remains active until canceled by another instruction from this G group (G0, G1, ...).
The configured dimensional data G90 or G91 applies to the end point and the intermediate
point.
Figure 3-18
Programming example
N5 G90 Z30 X40
N10 CIP Z50 X40 K1=40 I1=45
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Circle with end point and intermediate point specification using the example of G90
; Starting point circle for N10
; End point and intermediate point
Programming
3.3 Axis movements
3-37