5.2
Machine operating area
5.2.1
JOG mode
Operating sequences
Use the <JOG> key on the machine control panel to select the Jog mode.
To traverse the axes, press the appropriate key of the X or Z axes.
The axes will traverse continuously at the velocity stored in the setting data until the key is
released. If the value of the setting data is zero, the value stored in the machine data is
used.
If necessary, set the speed using the override switch.
When you additionally press the <Rapid traverse override> key, the selected axis will be
traversed at rapid traverse speed until both keys are released.
In the <Increment> mode, you can traverse by adjustable increments using the same operat-
ing sequence. The set number of increments is displayed in the status area. To deselect,
press <JOG> again.
The Jog start screen displays the position, feedrate, and spindle values, as well as the cur-
rent tool.
Figure 5-2
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
JOG main screen
Operating areas and operating modes
5.2 Machine operating area
5-3