Block Search - Siemens SINUMERIK 802D sl Programming And Operating Manual

7.4

Block search

Operating sequence
Requirements: The desired program has already been selected and the control system is in
the RESET state.
The block search function provides advance of the program to the required block in the part
program. The search target is set by positioning the cursor bar directly on the required block
in the part program.
Figure 7-5
Block search to block start
Block search to block end
Block search without calculation
The interruption location is loaded.
Use this softkey to perform the block search by entering a term you are looking for.
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Block search
Operator control (software)
7.4 Block search
7-5