Table 5-1 Description Of The Parameters In The Jog Start Screen - Siemens SINUMERIK 802D sl Programming And Operating Manual

Operating areas and operating modes
5.2 Machine operating area
Parameter
Table 5-1
Parameter
MCS
X
Z
+ X
– Z
Position
mm
Repos.
offset
G function
Spindle S
r.p.m.
Feed F
mm/min
Tool
Note
If a second spindle is integrated into the system, the workspindle will be displayed using a
smaller font. The window will always display the data of only one spindle.
The control system displays the spindle data according to the following aspects:
The master spindle (large display) is displayed:
- Idle,
- at spindle start
- with both spindles active
The workspindle (small display) is displayed:
- when starting the workspindle
The power bar applies to the spindle currently active. With both master spindle and work-
spindle active, the master spindle performance bar is displayed.
5-4
Description of the parameters in the JOG start screen
Explanation
Displays the axes existing in the machine coordinate system (MCS) or in the workpiece
coordinate system (WCS)
If you traverse an axis in the positive (+) or negative () direction, a plus or minus sign
will appear in the relevant field.
If the axis is already in the required position, no sign is displayed.
These fields display the current position of the axes in the MCS or WCS.
If the axes are traversed in the "Program interrupted" condition in the
distance traversed by each axis is displayed referred to the interruption point.
Displays important G functions
Displays the actual value and the setpoint of the spindle speed
Displays the path feedrate actual value and setpoint.
Displays the currently active tool with the current edge number
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Jog
mode, the
Grinding