Inclined Axis Programming (G05, G07) - Siemens SINUMERIK 802D sl Programming And Operating Manual

Programming
3.13 Inclined axis
3.13.2

Inclined axis programming (G05, G07)

Function
In Jog mode, the movement of the grinding wheel can either be cartesian or in the direction
of the inclined axis (the display stays cartesian). All that moves is the real U axis, the Z axis
display is updated.
In jog–mode, REPOS–offsets must be traversed using Cartesian coordinates.
In jog–mode with active "PTP–travel", the Cartesian operating range limit is monitored for
overtravel and the relevant axis is braked beforehand. If "PTP travel" is not active, the axis
can be traversed right up to the operating range limit.
Programming
G07
G05
The commands G07/G05 are used to make it easier to program the inclined axes. Positions
can be programmed and displayed in the Cartesian coordinate system. Tool compensation
and zero offset are included in Cartesian coordinates. After the angle for the inclined axis is
programmed in the NC program, the starting position can be approached (G07) and then the
oblique plunge-cutting (G05) performed.
Parameter
G07
G05
3-92
Approach starting position
Activates oblique plunge-cutting
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding