Program Setting Data - Siemens SINUMERIK 802D sl Programming And Operating Manual

Define

6.7 Program setting data

Note
Both calibration and measurement must always be done in the same direction.
6.7 Program setting data
Functionality
The setting data are used to define the settings for the operating states. These can be
changed as necessary.
Operating sequences
These can be found on the Offset parameters operating area.
Press the <Setting data> softkey. The start screen "Setting data" is displayed. Other softkey
functions are available here with which you can set various control system options.
Figure 6-16
JOG feedrate
Feedrate value in JOG mode
If the feedrate value is zero, the control system will use the value stored in the machine data.
Spindle
Spindle speed
Minimum / maximum
6-18
Setting data start screen
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding