Inclined Axis: Traang - Siemens sinumerik 840d Programming Manual

08.97
7
840D
NCU 572
NCU 573
7.4

Inclined axis: TRAANG

Programming
TRAANG(α) or TRAANG(α,n)
TRAFOOF
Explanation of the commands
TRAANG(α)
TRAANG(α,n)
α
TRAFOOF
If α (angle) is omitted or a zero entered, the
transformation is activated with the parameter
settings of the previous selection. On the first
selection, the defaults in the machine data are used.
An active TRAANG transformation is also
deactivated if one of the other transformations (e.g.
TRACYL, TRANSMIT, TRAORI) is activated on the
same channel.
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
810D 840Di
Transformations
7.4 Inclined axis: TRAANG
Activates the first declared inclined
transformation axis
Activates the nth declared
inclined transformation axis. n may not
exceed 2. TRAANG(α,1) corresponds to
TRAANG(α).
Angle of the inclined axis
Transformation off
7
7-247