Programmable Work Offset: Trans, Atrans - Siemens SINUMERIK 808D User Manual

11.2.6

Programmable work offset: TRANS, ATRANS

Fu n ctionality
The programmable work offset can be used:
● for recurring shapes/arrangements in various positions on the workpiece
● when selecting a new reference point for the dimensioning
● as a stock allowance when roughing
This results in the current workpiece coordinate system. The rewritten dimensions use this as a reference.
The offset is possible in all axes.
Programming
TRANS X... Y... Z...
ATRANS X... Y... Z...
TRANS
The instructions which contain TRANS or ATRANS each require a separate block.
See the following illustration for the example for programmable offset:
Programming example
N20 TRANS X20 Y15
N30 L10
N70 TRANS
Subroutine call - see Section "Subroutine technique (Page 132)".
84
; programmable offset, deletes old instructions for offsetting, rotation, scaling factor,
mirroring
; programmable offset, additive to existing instructions
; without values: clears old instructions for offset, rotation, scaling factor, mirroring
; Programmable offset
; Subroutine call; contains the geometry to be offset
; Offset cleared
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017