Ricoh B003 Service Manual page 559

Paper Height Sensor Installation
[A]
[B]
B361I112.WMF
[G]
[D]
[H]
B361I108.WMF
6. Remove the connector cover [A] and lower rear cover [B] (5 screws).
7. Pull out the two paper trays [C].
8. Install edge clamp [D] in the opening.
9. Connect the four paper height sensors [E] to the cable [F].
10. Install the four paper height sensors [E] as shown.
11. Install the four cable clamps [G], then clamp the cable as shown.
12. Lead the cable through the opening [H]. Secure the cable in place with the
edge clamp attached in step 8.
13. Connect the cable to CN234 on the PCB [I].
SM
CÓPIA NÃO CONTROLADA
[C]
[G]
[F]
1-3
CÓPIA NÃO CONTROLADA
PRINTER INSTALLATION
[E]
[I]
B003/B004/B006/B007
B361I113.WMF
B361I109.WMF