Ricoh B003 Service Manual page 981

Rev. 08/2003
SP6 Mode Number
6016* Original Size Decision
Priority
6017* Sheet Through Magnification
6105* Staple Position Adjustment
6113* Punch Hole Adjustment
1* 2-Holes
2* 3-Holes
6902* Fold Position Adjustment
SM
CÓPIA NÃO CONTROLADA
Function and [Setting]
Sets detection of an original size that is larger
than the size above the size assigned to the
original detection sensor which otherwise may not
be possible. This provides an alternate selection
for detection, other than that assigned with SP5-
131.
0 / 1
0: Allows settings shaded in table below.
1: Allows settings not shaded in table below.
Bit
7
6
5
4
3
2
1
0
Adjusts the magnification in the sub-scan
direction for ADF mode.
[–50.0 ~ +50.0 / 0.0 / 0.1%/step]
Use the
entering the value
Adjusts the staple position in the main scan
direction when using the two-tray finisher.
[–3.5~+3.5 / 0.0 / 0.5 mm step]
Press to toggle
staple toward the edge of the paper.
Adjusts the punch hole position.
[–7~+7 / 0 / 0.5 mm steps]
Press to toggle
holes toward the edge of the paper.
2-hole punches for Japan, North America,
Europe, and 4-hole punches for Northern Europe.
3-hole punches for North America, and 4-hole
punches for Europe.
Japan Only
5-37
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Setting
0
A4 (L) LT (L)
11" x 15" DLT (L)
DLG (L) 11" x 15"
LT (S) US Exec (S)
LT (L) 8* x 10" (L)
LG (L) F4 (L)
A4 (L) 16K (L)
8K (L) DLT (L)
key to toggle between + and - before
±
. A larger value shifts the
±
. A larger value shifts the
B003/B004/B006/B007
1