Ricoh B003 Service Manual page 1019

Firmware History for B003/B004/B006/B007
Firmware modified to correct the following:
1. When using signature level 2 on the NetWare Server, the printer does not connect to the
NetWare Server.
2. The printer cannot print more than one job sent from a CICS application on an IBM Main
Frame (e.g. OS/390) when the application uses lpd protocol unique to CICS.
3. The lpd process on the printer is interrupted when lpq/lprm commands with arguments
are executed more than 50 times after the printer has been turned on.
4. When trying to access the Web Status Monitor for a printer during printing via the ipp
port, the httpd process is occasionally interrupted.
5. When there are several messages displayed, such as error messages after a
malfunction, Apple Talk protocol is occasionally interrupted during printing.
6. When the printer is not ready due to an open cover, the message "Printer is not ready" is
not indicated in lpd or stat command.
7. When executing the prnlog command designate job ID 0, no information is indicated.
8. Even when the parameter settings changed by telnet are not successfully written into the
NVRAM, no error message is indicated as a command line.
9. The software allows any name to be entered as the computer name for NetBEUI.
10. When printing data with 0 byte by rcp, the NIB does not respond to the waiting client PC.
11. No settings are valid with the install shell of RedHat Linux Ver.7.1.
Change in Specification:
1. 2-byte code characters cannot be entered for a device name.
Firmware modified to correct the following:
1. After a communication failure breaks the connection between the NIB and Network
Twain driver, the driver is unable to re-establish connection (unless the A-C2 is powered
Off/On).
2. When 80000000(H) or more is registered in the Manager IPX Address 2 (Web Status
Monitor), the setting is changed to an unspecified one.
3. If several print jobs are sent one after another to the NIB via the IPP port of
SmartNetMonitor for Client, the NIB terminates printing. (Also, a print job sent by the
standard IPP port may be canceled).
4. The USTATUS information may be lost, depending on when the USTATUS is sent
during bi-directional communication over TCP/IP port 9100.
5. With bi-directional communication enabled for TCP port 9100, printing operation is
inhibited after data is sent from an application utility that does not support bi-directional
communication (e.g. Port Navi, MDP).
6. The IP address 0.0.0.0 can be set by the ifconfig command.
7. The wording of the message for saving data at logoff was corrected from "datas" to
"data".
Change in Specification:
1. Information such as the IP address and printing protocol (Client PCs) was added to the
syslog file for access restriction.
2. The display width for the ID of the prnlog command with telnet, rsh, and ftp was
expanded from 2 to 10 digits.
First mass production
CÓPIA NÃO CONTROLADA
Descriptions
CÓPIA NÃO CONTROLADA
Version
1.77
1.66
1.61
Page 7 of 15