Ricoh B003 Service Manual page 1027

Firmware History for B003/B004/B006/B007
1. While downloading PS fonts to a machine, the correct PS serial number cannot be
output.
2. PS error occurs when the following conditions have been met:
- Original size is the same as that loaded in the locked tray(s).
- The paper type is not specified in the driver.
- "AutoSelect Tray" is selected in the driver.
3. If the machine receives an A5 print job while "Error Skip" is activated and there is no
A5 loaded in any tray, the operation panel will display "Load A5 Paper (LEF)", even
though specification only supports A5 SEF.
4. Printing out the PS Configuration page:
Even though specification requires the machine to prompt the operator to load A4/LT
plain when there are no trays containing plain or recycled paper, the machine does not
display the message and allows the configuration page to be printed out onto any
paper type.
1. With print jobs containing mixed duplex/simplex pages, the job comes out either all
simplex or all duplex.
2. When there are different settings set for each page of the print job (e.g. paper type,
size), only one page is printed out.
3. If an input tray is locked as the priority tray (using Print Tray Priority) and Auto Continue
has been set to "0 minutes", an SC error is displayed when printing out more than two
pages of a PS config. page.
4. The product name for Pointy and Print cannot be changed.
First mass production
CÓPIA NÃO CONTROLADA
Symptom Corrected
CÓPIA NÃO CONTROLADA
Version
1.05
1.03
1.00
Page 15 of 15