Ricoh B003 Service Manual page 160

FUSING
[G]
[F]
1. Hot roller [A]
CAUTION: The hot roller is easily damaged. Always handle it carefully.
2. C-rings x2 [B] (both ends)
3. Drive gear [C]
4. Bushing x2 [D] (both ends)
5. Pressure roller [E]
6. Fusing knob [F] (! x1)
7. Bushing x2 [G] (both ends)
NOTE: 1) Before installing the new hot roller, peel off 3 cm (1 inch) from both
ends of the protective sheet on the new roller.
2) Never touch the surface of the rollers.
3) Work carefully to damaging the surface of the hot roller.
4) The standard pressure roller spring position is the upper position.
5) When reinstalling the hot roller assembly and pressure roller
assembly, make sure that the flange position of the bushings is as
shown.
6) When reinstalling the C-rings [B] of the hot roller, make sure that the
position of the C-rings is as shown.
B003/B004/B006/B007
CÓPIA NÃO CONTROLADA
[A]
[E]
3-56
CÓPIA NÃO CONTROLADA
[D]
B004R609.WMF
[B]
[C]
SM