Fax Application - Ricoh B003 Service Manual

Firmware History for B003/B004/B006/B007
08.00.00 Group destination from
LAN FAX driver
On-hook function
⇒
Unlimited number of
memory transmission
files from LAN FAX
Driver
For Korea

FAX APPLICATION:

Version
3.2.5
3.8.4 Handset
Ten-key response time
improved
Document Server –
scanning area (size)
Manual reception
disabled
Option Stamp displayed
3.8.9 Information Box
SP6-104: G4 Protocol
Dump List
Power off with handset
Off hook
CÓPIA NÃO CONTROLADA
Group addresses from the LAN FAX driver cannot be used for
memory broadcasting.
Memory transmission not possible after operator repeatedly
performs on-hook dial
Specification change:
The number of files that can be sent from the LAN FAX driver
for memory transmission has been changed from 64
unlimited.
To enable the "unlimited" setting:
Set the following switch, contained in firmware ver2.04 onward,
to a value of 1
SYS SW19 Bit 4 - Unlimited number of memory transmission
files from LAN FAX driver.
0: 64 jobs
1: Unlimited
Note: This bit SW is ineffective for memory transmission files
with cover sheets. The limit for such files is still 64.
When this SW is set to Unlimited, jobs 65 and onward will be
stored in the Smart Net Monitor for Client job history
(overwriting existing entries).
Communication fails even when the country code is set to
Korea.
Title
1st mass production
Some buttons are disabled after the handset is picked up and
put back several times.
Some buttons are disabled after a job is interrupted with off-
hook (reset) and the handset is put back.
It is possible to press to the On-hook button while "no paper" is
displayed.
The fax option malfunctions when several quick dials are
pressed in On-hook mode (handset down).
The alert continues to be displayed even after the handset is
put back.
When trying to send stored files from the Document Server, the
ten-key pad is disabled if the On-hook button is pressed twice
while still inside the Enter Password screen.
The response time of the ten-key pad has been increased.
When documents are scanned for storage (only) to the
Document Server, the machine does not prohibit changing the
size of the scanning area.
Manual reception is not possible while inside the User Code
Input screen.
The Stamp function is displayed in User Tool Settings even
though there is no Stamp option installed.
SC990 occurs when printing a message stored in the
Information Box.
The fax option malfunctions when printing out the G4 protocol
dump list without the ISDN option board installed.
The main power can be turned off even if the handset is off the
hook.
CÓPIA NÃO CONTROLADA
destination input on-hook cancel.
Symptom Corrected
Page 12 of 15