Ricoh B003 Service Manual page 977

Rev. 08/2003
SP5-xxx: Mode
SP5 Mode Number
5024* mm/inch Display Selection
5044 Operation Panel Bit SW
5104* A3/DLT Double Count
⇒
5106* 6* ADS Level Selection
5112* Non-Standard Paper
Selection
5113* Optional Counter Type
5118* Disable Copying
5120* Mode Clear Opt. Counter
Removal
5121* Counter Up Timing
5127* APS Mode
SM
CÓPIA NÃO CONTROLADA
Function and [Setting]
Selects the unit of measure.
After selection, turn the main power switch off and
on.
0: Europe/Asia 1: North America
0: mm, 1: inch
DFU
Specifies whether the counter is doubled for
A3/DLT.
0: No, 1: Yes
If is selected, the total counter counts up twice
when A3 or DLT paper is used.
Selects the image density level used in ADS
mode.
[1~7 / 4 / 1 notch per step]
Example: If you set SP5-106-6 to "2": Pressing
the Auto Image Density key toggles the display
off and manual notch 2 is selected.
Adjust this SP if the customer cannot attain clean
copies after performing automatic density
adjustment.
Determines whether a non-standard paper size
can be initialized for copying or not.
0: No, 1: Yes
If is selected, a non-standard size can be input
using the UP mode.
Selects the corresponding key for installed
devices such as a coin lock. Japan only
[0~5 / 0 / 1 step]
0 None.
1 Key card (RK3, RK4)
2 Key card (subtraction count setting)
3 Pre-paid card
4 Coin lock
5 MF key card
DFU
Clears all coin devices. Japan only
[0~2 / 0 / 1 step]
0: Normal reset.
1: Resets only when job finished or before job
begins.
2: Not normal reset.
Determines whether the optional key counter
counts up at paper feed or at paper exit.
0: Feed, 1: Exit
The total counter is not affected by this SP mode.
Selects whether the APS function is enabled or
disabled with the contact of a pre-paid card or
coin lock.
0: Enabled, 1: Disabled
5-29
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
B003/B004/B006/B007