Ricoh B003 Service Manual page 883

Tech Service Bulletin No. B003/B004/B006/B007 – 016
Page 3 of 4
2. Attach the Driven Roller [A] to the Pressure Plate [B], then peel off the outer layers of the double-sided
tape (2 places) on the Pressure Plate.
3. Set the Bushing [C] in the hole in the Pressure Plate, then mount the two together onto the Feed Shaft.
Note: Be careful not to let the exposed double-sided tape contact the Side Plate.
4. Set Bushing [D] in the cutout on the side of the Pressure Plate, then push in the Pressure Plate along
with the two bushings. After it is set in position, attach e-rings [E] and [F].
5. Press the Pressure Plate firmly against the Side Plate so that the double-sided tape catches and
secures the two together.
6. Attach the Gear [G].
7. Attach the Electrical Clutch [H].
8. Remove the Arm Tightener [N], Gear and Spring (not shown) attached to the original Tightener Bracket
removed in the Prep stage, and attach them to the new Tightener Bracket [I].
9. Attach the new Tightener Bracket [I] and Bushing [J] and new bushing [K]. Then, the tighten screws in
the order shown. (1,2 then 3)
10. Attach e-rings [L] and [M].
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA
[J]
[K]
[I]
[L]
[N]
[M]
Continued...