Ricoh B003 Service Manual page 791

Tech Service Bulletin No. B003/B004/B006/B007 – 004
Page 3 of 3
SECTION 3 - NECESSARY SP/UP SETTINGS:
3.2 SP MODES:
3.2.1. SP5-836-001 (Capture Function).
Enables/disables the Capture function.
When enabled, the settings screen for the capture function is displayed inside.
System Settings.
0: Disabled (default)
3.2.2. SP5-836-061 (Capture File Re-send).
Enables/disables re-sending of previously captured files to eCabinet.
When enabled, if the client PC operator accesses a Captured file stored in eCabinet and sends it to
the B003/B004/B006/B007, the machine will re-send this document to the eCabinet. This is to
provide an extra safeguard for file backup. However if users wish to minimize network traffic and free
up eCabinet memory, this function can be disabled.
0: Disabled
3.3 Copier UP Mode Explanation
Users need to perform the necessary settings; user tool/system settings/file transfer/Capture server IP
address, eCabinet IP address.
On the copier go to; user tools/system settings/key op tools/next button/capture priority.
On the copier go to; user tools/system settings/timer settings and set to customer's preference.
Explanation:
•
"OFF": Normal mode - eCabinet window does not pop up and there's no capture to eCabinet.
•
"OFF" Default: - eCabinet window pops up, select ecab user, and choose capture "ON" or OFF".
•
"ON" Default: - eCabinet window pops up, select ecab user, and choose capture "ON" or OFF".
•
"ON": - eCabinet window pops up, user must be selected, and capture mode is "ON" and can not be
changed.
•
"ON" NO DISPLAY: - eCabinet window and capture happens behind the scenes. Default user setup on
eCabinet under settings/advanced settings/capture control will always be the captured documents
owner.
✷ ✷ ✷ ✷ Example:
Capture priority for copier is set for default "ON". This way the eCabinet window pops up
every time Copier mode is used and the capture button is selected.
CÓPIA NÃO CONTROLADA
1: Enabled "ON" (must be set)
1: Enabled (default)
CÓPIA NÃO CONTROLADA