Input Check; Main Machine Input Check: Sp5-803 - Ricoh B003 Service Manual

5.1.4 INPUT CHECK

Main Machine Input Check: SP5-803

1. Enter the SP mode and select SP5-803.
2. Enter the number (1 – 13) for the item that you want to check. A small box will
be displayed on the SP mode screen with a series of 0's and 1's.
The meaning of the display is as follows.
0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
3. Check the status of each item against the corresponding bit numbers listed in
the table below.
Number Bit Description
7 Fusing Exit Sensor
6 Near End Sensor 2
5 Near End Sensor 1
4 Not Used
1: Paper Feed
1 (Upper Tray)
3 Paper Size Sensor 4
2 Paper Size Sensor 3
1 Paper Size Sensor 2
0 Paper Size Sensor 1
7 Duplex Unit Set Sensor
6 Near End Sensor 2
5 Near End Sensor 1
4 Not used
2: Paper Feed
2 (Lower Tray
3 Paper Size Sensor 4
2 Paper Size Sensor 3
1 Paper Size Sensor 2
0 Paper Size Sensor 1
7 Zero Cross Signal
6 Transfer Belt Unit HP Sensor
5 Exhaust Fan Lock Signal
4 Cooling Fan Lock Signal
3: Registration
and Others
3 Main Motor Lock Signal
2 Toner Overflow Sensor
1 Cover Open
0 Registration Sensor
SM
CÓPIA NÃO CONTROLADA
Activated
Activated
Activated
---
Activated
Activated
Activated
Activated
Unit set
Off
Off
---
Activated
Activated
Activated
Activated
Detected
Not present
Not locked
Not locked
Not locked
Tank not full
Cover closed
Paper detected
5-49
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Reading
0 1
Deactivated
Deactivated
Deactivated
---
Deactivated
Deactivated
Deactivated
Deactivated
Unit not set
On
On
---
Deactivated
Deactivated
Deactivated
Deactivated
Not detected
Present
Locked
Locked
Locked
Tank full
Cover opened
Paper not detected
B003/B004/B006/B007