Ricoh B003 Service Manual page 677

BIT SWITCHES
System Switch 1E
No FUNCTION
5 Address display priority in the
AI redial mode
0: RTI/CSI
1: Telephone number
6 Not used
7 RAM initialization after the
optional Function Upgrade unit
is installed or removed
0: Enabled
1: Disabled
B003/B004/B006/B007
CÓPIA NÃO CONTROLADA
0: When the machine has both RTI/CSI and the
telephone number information, the machine displays
RTI/CSI.
1: The machine always displays the telephone
number.
Do not change the setting
When the machine detects that a Function Upgrade
unit has been installed or removed, the machine
shows the following message on the display for the
customer.
"Adding/Removing FAX Feature Expander causes
data loss. Turn Main Power Switch off and
remove/replace it to avoid loss. To continue, press
Yes."
If Yes is pressed, the machine initializes the RAM to
the "with" or "without card" configuration. However,
changing this bit to "1" disables this initialization,
even if Yes is pressed.
Change this bit to 1 after installing the Function
Upgrade unit.
0: When the above message is displayed, the
machine initializes the RAM if Yes is pressed. The
amount of data lost depends on whether the board
is in or out. To avoid losing data, the user must
switch off immediately and put the Function
Upgrade unit back in.
1: When the above message is displayed, the
machine does not initialize the RAM even if Yes is
pressed. However, the fax unit cannot be used until
the user switches off, puts the Function Upgrade
unit back in, then switches back on. No data is lost.
3-20
CÓPIA NÃO CONTROLADA
SP No. 1-101-031
COMMENTS
SM