Ricoh B003 Service Manual page 81

[B]
9. Connect the harnesses [A] and clamp them as shown.
NOTE: No special DIP switch settings are required for this punch unit. The
punch unit sends an identification signal to the machine board so it
knows what type of punch unit has been installed.
10. Slide the hopper [B] into the machine.
11. Fasten the two 1 mm spacers [C] to the rear frame for future adjustment.
NOTE: The spacers are used to adjust the horizontal positioning of the holes.
12. Reassemble the finisher and check the punch operation.
SM
CÓPIA NÃO CONTROLADA
B377I105.WMF
1-43
CÓPIA NÃO CONTROLADA
PUNCH UNIT INSTALLATION
[A]
B377I106.WMF
B003/B004/B006/B007
[C]