Ricoh B003 Service Manual page 901

FIRMWARE MODIFICATION HISTORY
⇒
B003/B004/B006/B007 ENGINE SOFTWARE MODIFICATION HISTORY
Following a book scan job at 25-44%
reduction, the first page of a (100%) DF job is
printed out as a blank page.
When a finisher jam occurs with the 1000-
sheet Finisher, sometimes the location of the
jammed paper is not displayed.
Fusing-related SC errors happen frequently
after SP1104-1 is changed from fusing
temperature control to phase control.
When the operation switch is turned Off/On,
the value of SP6017 (Sheet Through
Magnification) is reset to default (0).
When fax transmission is stopped by a DF
jam or other error, the display still reads
"Scanning
If the paper stops inside the bridge unit where
the sensors cannot detect it (mainframe +
mailbox configuration only), the jam location is
not displayed on the panel.
The pressure roller deforms (temporary
change) after the machine is in Standby mode
for an extended period of time, eg 2 to 3 days.
Fusing related SC codes (541, 542) and/or
incomplete fusing occurs when making copies
first thing in the morning (especially in cold
environments).
When printing document feeder A4 SEF
originals with Create Margin onto A3 paper at
141%, black lines appear along the right edge
(along the subscan direction).
B003/B004/B06/B007
CÓPIA NÃO CONTROLADA
Blank page of a
DF job
Jammed paper
location is not
displayed
SC error at
Phase control
Value of
SP6017 is reset
to default
Scanning"
message
remains after
Fax Tx
interrupted".
Jam location not
displayed with
mainframe +
mailbox
Pressure Roller
temporarily
deforms
SC541, SC542
Vertical black
lines along right
edge
8-2
CÓPIA NÃO CONTROLADA
Rev. 09/2002
B0045112 G 2.20
B0045112 H 2.21
B0045112 K 2.26
B0045112 L 2.28
B0045112 M 2.29
SM