Address Range - Motorola RFS7000 Reference Manual

17-34 Motorola RF Switch CLI Reference Guide
the L3 interface is 192.168.0.0/16, DHCP is not enabled on 192.168.0.0/16, since it is
different from 192.168.0.0/24.
3. A network pool without any include range is as good as not having a pool. Add a
include range using the

address range 192.168.0.30 192.168.0.30

4. To work properly, a host pool should have the following 3 items configured:
• client-name (CLI is
• fixed-address CLI is
• hardware-address/client-identifier
The hardware address is
The client-identifier is
If you use
the client-identifier when it requests for IP address. The Client - identifier has to be
configured in the DHCP Client as an ASCII value and the same has to be used in the
DHCP server option (for example, the Client- identifier option).
5. A host pool should have its corresponding network pool configured, otherwise the host
pool is useless. The fixed IP address configured in the host pool must be in the subnet
of the corresponding network pool.
6. If you create a pool and map it to an interface, it automatically gets enabled, provided
DHCP is enabled at a global level. Use the
a per pool/interface basis.
7. To set a newly created pool as a network pool, use one of the following commands:
• network (for example, network 192.168.0.0/24)
• address range (for example, address range 192.168.0.30 192.168.0.50)
8. To set a newly created pool as a host pool, use one of the following commands:
• host (for example, host 192.168.0.1)
• client-name (For example, client-name "kaveri")
• client-identifier (For example, client-identifier "aabb:ccdd")
• hardware-address (For example, hardware-address "aa:bb:cc:dd:ee:ff")
9. A pool can be configured either as the host pool or network pool, but not both.
address range
client-name <name>
host <ip>
hardware-address <addr>
client-identifier <id>
client-identifier
command.
)
)
instead of
hardware-address
no network
, a DHCP client sends
command to disable DHCP on