Motorola RFS7000 Reference Manual page 698

22-8 Motorola RF Switch CLI Reference Guide
<1-256>
A single RFID reader index. Select a value between
<1-256>
• antenna – RFID Antenna configuration commands
• <1-8> – A single Antenna index
• range – A list or range (3-7) of antenna
indices
• any – Any RFID reader antenna
• coordinates – Configures reader location coordinates
• x <value> – X coordinate for reader. Select a
value between <-65535-65535>.
• y <value> – Y coordinate for reader. Select a
value between <-65535-65535>.
• z <value> – Z coordinate for reader. Select a
value between <-65535-65535>.
• date <MM:DD:YYYY> – Configures the RFID reader date
• description – Configures the description of this RFID
reader
• diag – Configures reader diagnostics parameters
• enable – Enables reader diagnostics
• period <1-300> – Configures the reader's
diagnostic monitoring period in minutes
• enable – Enables/connects specified RFID reader
• heartbeat-period <1-60> – Sets the RFID reader device
heartbeat interval in seconds (default is 5 seconds)
• id – Reader ID (IP address or MAC)
• mode – Reader operating mode
• autonomous – Configures as autonomous
mode
• on-demand – Configures as on-demand
mode