15-12
Motorola RF Switch CLI Reference Guide
15.1.8 permit
Standard ACL Config Commands
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
permit(A.B.C.D/M|any|host)
permit any(log|rule-precedence)
permit any log(rule-precedence)<1-500>
permit any rule-precedence<1-500>
permit host A.B.C.D
Parameters
A.B.C.D/M
any
host
Usage Guidelines
Use this command to allow traffic based on the source IP address or network address. The
last ACE in the access list is an implicit deny statement.
Whenever the interface receives the packet, its content is checked against all the ACEs
in the ACL. It is allowed based on the ACL's configuration.
Defines the source IP address range to match
Any source IP address
• log – The log matches against this entry
• rule-precedence<1-500> – Defines the access-list
Single host address.
• A.B.C.D – Defines the exact source IP address to
NOTE: The log option is functional only for router ACLs. The log option
displays an informational logging message about the packet matching
the entry sent to the console.
entry precedence
match