Use the
(config-if
associated with the switch.
12.1 Interface Config Commands
Table 12.1
summarizes the
Command
clrscr
crypto
description
duplex
end
exit
help
ip
mac
) instance to configure the interfaces — Ethernet, VLAN and tunnel
commands:
config-if
Table 12.1 Interface Config Command Summary
Description
Clears the display screen
Defines the encryption module
Creates an interface specific description
Sets the duplex mode used by the interface
Ends the current mode and moves to the EXEC mode
Ends the current mode and moves to the previous mode
Displays the interactive help system
Sets the IP address for the assigned ethernet, VLAN or
tunnel
Applies a MAC access list to a gigabit ethernet
interface
Interface Instance
Ref.
page 12-3
page 12-4
page 12-5
page 12-6
page 12-7
page 12-8
page 12-9
page 12-10
page 12-13