Deny - Motorola RFS7000 Reference Manual

16-4 Motorola RF Switch CLI Reference Guide

16.1.2 deny

MAC Extended ACL Config Commands
Specifies packets to reject
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
(deny)[any|host source MAC address|source MAC/source MAC address
mask] [any|host destination MAC address|destination MAC/destination
MAC address mask](vlan <vlan-id>)(dot1p <dot1p-value>)
[type value|ip|ipv6|arp|vlan|wisp|0-65535] [log]
[rule-precedence access-list-entry precedence]
Parameters
Source Mask
NOTE: Use a decimal value representation of ethertypes to implement
a
permit/deny/mark
Extended MAC ACLs provide the hexadecimal values for each listed
ethertype. The switch supports all ethertypes. Use the decimal
equvilant of the ethertype listed for any other ethertype.
designation for a packet. The command set for
Define a source mask specifying the bits to match.
The source wildcard can be any one of the
following:
• xx:xx:xx:xx:xx:xx/
xx:xx:xx:xx:xx:xx–Source MAC
address and mask
• any – Any source host
• host – Exact source MAC address to match