Duplex - Motorola RFS7000 Reference Manual

12-6 Motorola RF Switch CLI Reference Guide

12.1.4 duplex

Interface Config Commands
Specifies the duplex mode
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
duplex(auto|full|half)
Parameters
auto
full
half
Usage Guidelines
The duplex defines the communication used by the port. The switch (by default) is set in
the auto duplexmode. In auto mode, the duplex is selected based on connected network
hardware
NOTE:
• Duplexity can only be set for an Ethernet Interface. Enter the
instance using the
(config-if)
mode
• The duplex cannot be set until the speed is set to a non-auto value
Sets the ports duplexity automatically. The port
automatically detects whether it should run in full or
half-duplex mode
Sets the port in full-duplex mode
Sets the port in half-duplex mode
parameter of the
eth interface