Creating Helper Address Using Dhcp Server - Motorola RFS7000 Reference Manual

nat
Usage Guidelines
IPv4 commands are not allowed on a L2 interface. Use the
to attach an access list to an interface. Use the
the access list from the interface
Use
mac access-group
Use the
[no] ip [options]
Example
RFSwitch(config-if)#ip access-group 110 in
RFSwitch(config-if)#
RFSwitch(config-if)#ip address 192.168.234.1/24
RFSwitch(config-if)#

12.1.8.1 Creating Helper Address using DHCP Server

Follow the steps below to create a helper address on VLAN 2000 for using a DHCP server
on VLAN 1000:
RFSwitch(config)#interface vlan 1000
RFSwitch(config-if)#ip address 172.168.100.1/24
RFSwitch(config-if)#interface vlan 2000
RFSwitch(config-if)#ip address 172.168.200.1/24
RFSwitch(config-if)#ip helper-address 172.168.100.10 vlan 1000
RFSwitch(config-if)#
Sets Network Address Translation (NAT) parameters
• inside – Inside interface
• outside – Outside interface
to attach a MAC access list to an interface
command to undo IP based interface configurations
Interface Instance
ip access-group
no ip access-group
12-11
command
command to remove