Power - Motorola RFS7000 Reference Manual

12.1.13 power

Interface Config Commands
Invokes PoE commands to configure PoE power limit and priority for a port
Supported in the Following Platforms:
• RFS6000
Syntax
power [limit <0-30>|priority (critical|high|low)]
Parameters
limit <0-30>
priority (critical|high|low) Sets PoE priority for port
Usage Guidelines
Use
[no] power
Example
RFSwitch(config)#interface ge1
RFSwitch(config-if)#no power
RFSwitch(config-if)#exit
RFSwitch(config)#interface ge2
RFSwitch(config-if)#power limit 14
RFSwitch(config-if)#exit
SWITCH NOTE: This command is not supported with:
• WS5100
• RFS7000
Sets the PoE power limit for the port in watts. The upper
limit is restricted to 29.7 watts
• critical – Sets the PoE priority as critical priority
• high – Sets the PoE priority as high priority
• low – Sets the PoE priority as low priority
to rollback the PoE configurations and set back the default configuration
Interface Instance 12-19