Motorola RFS7000 Reference Manual page 637

copy-config-from
[<1-1000>|default-11a|
default-11b|
default-11bg]
description
detector
dtim-period<1-50> bss
<1-4>
enforce-spec-mgmt
(enable)
enhanced-beacon-table
enhanced-probe-table
location-led
[start-flashing|stop-
flashing]
location-message
Copies the configuration from a previously configured radio
• <1-1000> – Defines a single radio index
• default-11a – Uses the default 11a configuration
template
• default-11b – Uses the default 11b configuration
template
• default-11bg – Uses the default 11bg configuration
template
Defines a description for this radio
Dedicates this radio as a detector. No mobile units can
associate to a detector
Set the DTIM period (number of beacons between
successive DTIMs)
radio dtim-period<1-50> bss<1-4>
• <1-50> – Sets the DTIM period
• bss <1-4>– BSS index
Enforces spectrum management checks on specified radios.
Only mobile units that advertise spectrum management
capabilities will be allowed to associate on this radio.
Enables the enhanced beacon table for AP locationing
Enables the enhanced probe table for MU locationing
Changes the mode of operation of the LEDs on an AP
• start-flashing – Requests parent-ap of specified radio to
begin flashing its LEDs to help locate it
• stop-flashing – Requests parent-ap of specified radio to
revert its LEDs to normal mode of operation
Specifies a message sent to all mobile units that associate
with these radios. This message should not exceed 80
characters.
Wireless Instance 20-49