Client - Motorola RFS7000 Reference Manual

20-16 Motorola RF Switch CLI Reference Guide

20.1.10 client

Wireless Configuration Commands
Use this command to configure a wireless client. This command creates an exclude-list or
include list. Creating a list moves the user to a new mode.
(config-wireless-client-list)
Refer to config-wireless-client-list on page 20-18
command summary.
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
client {exclude-list|include-list}(NAME)
Parameters
exclude-list
include-list
Example
RFSwitch(config-wireless)#client exclude-list JustMe
RFSwitch(config-wireless-client-list)#
.
Sets the wireless client exclude list configuration. A MU
NAC check is conducted, except for those in the exclude
list. Devices in the exclude list will not have a NAC check
performed.
Defines the wireless client include list configuration. No
MU NAC check is conducted, except for those in the include
list. Devices in the include-list will have NAC checks.
for
(config-wireless-client-list)