Redundancy - Motorola RFS7000 Reference Manual

5.1.31 redundancy

Global Configuration Commands
Configures redundancy group parameters
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
redundancy [auto-revert (enable)|auto-revert-period <1-1800>|
dhcp-server (enable)|discovery-period <10-60>|enable|
group-id <1-65535>|handle-stp (enable)|heartbeat-period <1-255>|
hold-period <10-255>|interface-ip <IP Address>|
manual-revert|member-ip <IP address>|mode (primary|standby)]
Parameters
auto-revert (enable)
auto-revert-period
<1-1800>
dhcp-server (enable)
discovery-period <10-60> Sets the redundancy discovery interval in seconds. The
enable
group-id <1-65535>
handle-stp (enable)
heartbeat-period <1-
255>
hold-period <10-255>
interface-ip <Switch IP>
manual-revert
Enables auto-revert
Sets the redundancy auto-revert delay interval in minutes.
The default is 5 minutes
Enables the DHCP redundancy protocol
default is 30 seconds
Enables the redundancy protocol
Sets the cluster ID (default cluster ID is 1)
Delays the redundancy protocol state machine exec,
considering STP
Sets the redundancy heartbeat interval
Sets the redundancy hold interval
Sets the redundancy interface IP address
Reverts standby to non-active mode
Global Configuration Commands 5-67