17.1.1 address
DHCP Config Commands
Specifies a range of addresses for the DHCP network pool
Supported in the Following Platforms:
• WS5100
• RFS7000
• RFS6000
Syntax
address (range) (low IP address) (high IP address)
Parameters
range (low IP address) (high IP
address)
Usage Guidelines
Use the
address
DHCP server assigns IP address to DHCP clients from the address range. A high IP address
is the upper limit for providing the IP address, and a low IP address is the lower limit for
providing the IP address.
Use the
no address (range)
Example
RFSwitch(config-dhcp)#address range 2.2.2.2 2.2.2.50
RFSwitch(config-dhcp)#
Adds an address range for the DHCP server
comand to specify a range of addresses for the DHCP network pool. The
command to remove the DHCP address range.
• low IP address – Defines the first IP address
in the address range
• high IP address – Defines the last IP address
in the address range
DHCP Server Instance
17-3