Redundancy-Group - Motorola RFS7000 Reference Manual

2.2.20 redundancy-group

Common to all modes
This command displays the switch's IP address, number of active neighbors, group license,
installed license, cluster AP adoption count, switch adoption count, hold time, discovery
time, heartbeat interval, cluster id and switch mode.
In a cluster, this command displays the redundancy runtime and configuration of the
"self-switch". Use
parameters.
Syntax
show redundancy-group (config | runtime)
Parameters
config
runtime
Example
RFSwitch(config)#show redundancy-group
Redundancy Group Configuration Detail
Redundancy Feature
Redundancy group ID
Redundancy Mode
Redundancy Interface IP
Number of configured peer(s)
Heartbeat-period
Hold-period
Discovery-period
Handle STP
Switch Installed License
Switch running image version
Auto-revert-period
Auto-revert Feature
DHCP-Server Redundancy
Redundancy Group Runtime Information
Redundancy Protocol Version
Redundancy Group License
Cluster AP Adoption Count
Switch AP Adoption Count
Redundancy State
Radio Portals adopted by Group
to view only configuration information and/or
config
Displays configured redundancy group information
Displays runtime redundancy group information
Common Commands
: Disabled
: 1
: Primary
: 0.0.0.0
: 0
: 5 Seconds
: 15 Seconds
: 30 Seconds
: Disabled
: 48
: 3.1.0.0-008D
: 5 mins
: Disabled
: Disabled
: 2.0
: 0
: Not Applicable
: Not Applicable
: Disabled
: Not Applicable
2-61
runtime