Configuring Redundancy Group Membership - Motorola RFS7000 Series System Reference Manual

Connectivity Status
Access Ports on this
switch
Adoption capacity on
this switch
Rogue Access Ports
on this switch
Radios on this switch Displays the number of radios used with this switch.
Self-healing radios on
this switch
Mobile Units on this
switch
4. The Apply and Revert
editable parameters to save or revert.

5.4.2 Configuring Redundancy Group Membership

The redundancy group should be disabled to conduct an Add/Delete operation. There are a minimum of 2
members needed to comprise a Redundancy Group, including the initiating switch
To configure switch redundancy memberships:
1. Select Services
The Redundancy screen displays with the Configuration tab selected.
Displays the current connectivity status of the cluster membership.
Displays the total of the number of access ports adopted by this
switch.
Displays the AP adoption capability for this switch. Compare this
value with the adoption capacity for the entire cluster to determine
if the cluster members (or this switch) have adequate adoption
capabilities.
Displays the number of rogue APs detected by this switch.
Compare this value with the cumulative number of rogues detected
by the group to discern whether an abundance of rogues has been
located by a particular switch and thus escalates a security issue.
Displays the number of radios on this switch with self-healing
enabled. Compare this value with the total number of radios within
the group to determine how effectively radios can self-heal if
problems exist.
Displays the number of MUs currently associated with the radio(s)
used with this switch. Compare this number with the number of
MUs within the group to determine how effectively MUs are
distributed within the cluster.
buttons are unavailable for use with the Status screen, as there are no
> Redundancy from the main menu tree.
5-41
Switch Services