Configuring Redundancy Group Membership - Motorola RFS Series Reference Manual

5-42 Motorola RF Switch System Reference

5.4.3 Configuring Redundancy Group Membership

The redundancy group should be disabled to conduct an Add/Delete operation. There are a minimum of 2
members needed to comprise a Redundancy Group, including the initiating switch
To configure switch redundancy memberships:
1. Select Services
The Redundancy screen displays with the Configuration tab selected.
2. Select the Member
3. Refer to the following information within the Member tab:
IP Address
Status
Last Seen
Adoption Count
> Redundancy from the main menu tree.
tab.
Displays the IP addresses of the redundancy group member.
Displays the current status of this group member. This status could have the
following values:
• Configured - The member is configured on the current wireless service module.
• Seen - Heartbeats can be exchanged between the current switch and this
member.
• Invalid - Critical redundancy configuration parameter(s) of the peer (heartbeat
time, discovery time, hold time, Redundancy ID, Redundancy Protocol version
of this member) do not match this switch's parameters.
• Not Seen - The member is no more seen by this switch.
• Established - The member is fully established with this current module and
licensing information already been exchanged between this switch and the
member.
• Unknown - No status information could be obtained.
Displays the time when this member was last seen by the switch.
Displays the number of Access Ports adopted by this member.