3. Carefully lay the DPI blade on a flat, static-protective surface.
4. Remove the cover of the DPI blade. See "Removing the DPI blade cover" on
5. Remove the XFP module if one is installed in the DPI blade. See "Removing an
6. Remove the SFP module if one is installed in the DPI blade.
7. Disconnect the control-panel cable from the control-panel connector.
8. Press the bezel-assembly release on both sides and pull the bezel assembly
9. If you are instructed to return the bezel, follow all packaging instructions, and
Replacing the bezel assembly
The following illustration shows how to install the bezel assembly.
To install the DPI blade bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Carefully slide the bezel assembly onto the DPI blade until it clicks into place.
3. Connect the control panel cable to the control panel connector on the system
page 30 for more information.
XFP module" on page 32 for more information.
away from the DPI blade.
use any packaging materials for shipping that are supplied to you.
Bezel-assembly
release (both sides)
on page 25.
board.
Control-panel
cable
Bezel
Control-panel
connector
Chapter 4. Removing and replacing DPI blade components
37