Table of Contents
Advertisement
Completing the installation
To complete the installation, you must reinstall the bezel, reinstall the frame-support
bracket (see "Removing and installing the support bracket" on page 17), reinstall
the side cover, connect all the cables and, for certain options, run the
Configuration/Setup Utility program. Follow the instructions in this section.
Replacing the bezel
Complete the following steps to replace the bezel:
1. Insert the two tabs on the bottom of the bezel into the matching holes on the
2. Push the top of the bezel toward the server until the two tabs at the top of the
3. For non-hot-swap and simple-swap models, reinstall the door hatch on the
4. For hot-swap models, make sure that the side cover is unlocked; then, slide the
Replacing the side cover
If you removed the support bracket or bezel, reinstall it before you replace the side
cover. See "Removing and installing the support bracket" on page 17 and
"Replacing the bezel."
Note: The rear adapter retaining bracket rests against the server side cover. You
Complete the following steps to replace the side cover:
1. Before installing the cover, check that all cables, adapters, and other
2. Insert the tabs inside the cover into the slots on the server chassis.
3. Close the cover-release latch to secure the side cover in place.
4. Lock the side cover.
38
xSeries 206 Type 8482: Installation Guide
server chassis.
bezel snap into place.
server.
drive-bay lock bar to the right. The lock bar locks when you lock the side cover
key lock.
might find it easier to lay the server on its side to replace the side cover.
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
Note: The cover-release latch must be in the unlocked (opened) position before
you install the side cover.
Note: Make sure that each tab on the side cover is in its corresponding slot
before closing the cover-release latch.
Advertisement
Table of Contents
