5. If you have other options to install or remove, do so now; otherwise, go to
Completing the installation
To complete your installation, you must reinstall the bezel, reinstall the side cover,
connect all the cables and, for certain options, run the Configuration/Setup Utility
program. Follow the instructions in this section.
Replacing the bezel
The following illustration shows how to install the bezel on the server.
Complete the following steps to replace the bezel:
1. Insert the two tabs on the bottom of the bezel into the matching holes on the
2. Push the top of the bezel toward the server until the two tabs at the top of the
3. For hot-swap hard disk drive models, make sure the side cover is unlocked;
34
IBM xSeries 225 Type 8647: Installation Guide
"Completing the installation".
server chassis.
bezel snap into place.
then, insert the hot-swap lock bar into the slots on the bezel and rotate it to the
locked position. The hot-swap lock bar locks when you lock the side cover key
lock.