Replacing The Top Cover, Bezel, And Front Cover; Removing The Adapter - IBM System x3800 Problem Determination And Service Manual

Replacing the top cover, bezel, and front cover

To install the top cover, bezel, and front cover, complete the following steps:
1. Make sure that all internal cables are correctly routed.
2. Set the cover on top of the server so that approximately 13 mm (0.5 inch)
3. Make sure that the cover-release latch is up.
4. Slide the top cover forward and into position, pressing the release latch closed.
5. To install the bezel, tilt the bezel and insert the bottom tabs of the bezel into the
6. (Tower model only) To install the front cover, tilt the front cover and insert the

Removing the adapter

To remove a PCI adapter, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
extends from the rear.
matching slots in the server chassis and push the top of the bezel toward the
server until the retention tabs snap into place.
bottom tabs of the front cover into the matching slots in the bezel and push the
top of the cover toward the server until the locking tabs snap into place; then,
lock the front cover.
PCI retaining bar
PCI divider
on page 113.
Tab
Attention
LED
(yellow)
Power
LED
(green)
Chapter 4. Removing and replacing server components
Adapter-
retention
latch
119