Configuration Checklist Of Sipass; Configuration Procedure - Siemens DMS8000 MP4.30 Connectivity Manual

2.3

Configuration checklist of SiPass

2.4

Configuration procedure

6
Building Technologies
Fire Safety & Security Products
Fig. 1 Adding the SiPass Driver (A)
Note: The Composer plug-in #252401 is required.
Verify that you have satisfied the items needed in the first checklist before proceed-
ing to the configuration procedure that follows.
ITEMS NEEDED FOR CONFIGURATION

The SiPass system should be configured and reachable, either locally (on the
same PC as MM8000/MK8000) or over the network, for importing the SiPass
database into the Composer structure.
Alternatively, the SiPass export file (.XML) should be created, using the utility
available in MM8000/MK8000 (SiPass Export Tool), and then imported off-line
into Composer.

Plug-ins needed:
Plug-in #252501, which must be installed before you can configure your sys-
–
tem.
The following are the configuration procedures for SiPass.
Adding the SiPass Driver
1. Open the Composer project.
2. If not already done, add the SiPass Driver ( see 2.2 at pag.5).
Adding the folder for the Access Control
 Optionally, add one or more folders.
Adding the SiPass subsystem
1. Select the destination folder.
2. In the left-hand bar, select the Access Control folder
and then the SiPass icon
048_DMS_DMS8000_Connectivity_Access_Control_MP4.30_A6V10062451_a_en
Configuring SiPass Access Control System
.
06.2010