Table of Contents
Advertisement
Figure 66. Screws removal
Step 7.
Slowly lift the optional front 2.5-inch hot-swap hard disk drive cage out of the node.
Figure 67. Optional front 2.5-inch hot-swap hard disk drive cage removal
Step 8.
If you are instructed to return the optional front hard disk drive cage, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
Installing the optional front 2.5-inch hot-swap hard disk drive cage
Use this information to install the optional front 2.5-inch hot-swap hard disk drive cage.
Before you install the optional front 2.5-inch hot-swap hard disk drive cage, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
Screws
M3x0.5 L3 patch screw
2.5-inch hard
disk drive cage
.
Chapter 5
Removing and replacing components
143
Advertisement
Table of Contents
Troubleshooting
