Figure 38. Battery cable connection
Attention:
• Make sure the cable passes through the cable clips.
• Make sure that the cable is not pinched and does not cover any connectors or obstruct any
components on the system board.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 73.
Installing a hot-swap backplane on the rear hard disk drive cage
Use this information to install a hot-swap backplane on the rear hard disk drive cage.
The following illustrations show two different types of hot-swap backplanes.
• Type 1 - SATA
Attention: This backplane has to be cascaded with the front backplane to make the master-slave
connection.
.
Chapter 2
Installing optional devices
51