Table of Contents
Advertisement
Thermal sensor
connector
Figure 59. Thermal sensor board installation for 5U server model with hot-swap power supplies
7. Connect the thermal sensor connector to the system board.
8. If you have other devices to install, do so now. Otherwise, go to
75.
Completing the installation
Use this information to complete the installation.
To complete the installation, complete the following steps:
Step 1.
If you removed the bezel, reinstall it (see
Step 2.
If you removed the lower bezel, reinstall it (see
Step 3.
If you removed the upper bezel, reinstall it (see
Step 4.
If you removed the air baffle, reinstall it (see
Step 5.
If you removed the side cover, reinstall it (see
Step 6.
Reconnect the cables and power cords (see
Step 7.
Update the server configuration (see
Step 8.
Start the server. Confirm that it starts correctly and recognizes the newly installed devices, and
make sure that no error LEDs are lit.
Step 9.
(Business Partners only) Complete the additional steps in
page
25.
Replacing the bezel
This procedure applies only to 4U server models with non-hot-swap power supplies.
To install the bezel on 4U server models with non-hot-swap power supplies, complete the following steps.
1. Read the safety information in
2. Insert the three tabs on the bezel into the corresponding holes in the front of the server.
3. Rotate the bezel to the server until it locks securely into place.
Cable clips
"Replacing the bezel" on page
"Updating the server configuration" on page
"Safety" on page v
"Completing the installation" on page
"Replacing the lower bezel" on page
"Replacing the upper bezel" on page
"Replacing the air baffle" on page
"Replacing the side cover" on page
"Connecting the cables" on page
"Instructions for Business Partners" on
and
"Installation guidelines" on page
Chapter 2
75).
76).
77).
78).
80).
82).
83).
31.
.
Installing optional devices
75
Advertisement
Table of Contents
Troubleshooting
