Figure 103. Bezel removal
Step 6.
Pull the top of the bezel out slightly; then, rotate it downward until the tabs on the bottom of the
bezel disengages from the chassis and set it aside.
Step 7.
If you are instructed to return the front bezel, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the bezel
Use this information to install the bezel.
To install the bezel, complete the following steps:
Step 1.
Insert the tabs on the bottom of the bezel into the holes on the chassis.
Step 2.
Rotate the bezel upward to the server and reinstall the bezel screws. Then, install the EIA quick
latch.
Figure 104. Bezel installation
Step 3.
Install the server into the rack enclosure and push the server into the rack until it clicks into place.
.
Chapter 6
Removing and replacing structural parts
191