Terminals And Connectors - Christie DHD800 Setup Manual

Terminals and Connectors

q
u
q USB CONNECTOR (Series B)
USB connector is used to service the projector.
w 5 BNC INPUT JACKS
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Pb/Cb,
and Pr/Cr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks.
e D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog D-sub 15-pin
type) to this terminal.
r MONITOR OUT TERMINAL
This terminal can be used to output the incoming
analog RGB, component, or composite video
out signals from INPUT 1-2 terminal to the other
monitor.
t DVI INPUT TERMINAL
Connect computer output (Digital/DVI-D type) to
this terminal.
HDTV (HDCP Compatible) signal can be also
connected.
y HDMI
Connect the HDMI output signal from video
equipment to this terminal.
DHD800 Setup Guide
020-000247-02 Rev. 1 (01-2012)
w e
i
- 8 -
r t
o !0 !1
u S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack.
i SERIAL PORT IN TERMINAL
If you control the projector through RS-232C
from a computer, you must connect a cable (not
supplied) from your computer to this terminal.
o SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT
IN. More than two projectors can be controlled
through RS-232C from one computer by
connecting SERIAL PORT IN of another projector
to this terminal.
!0 LAN port
Connecting the Ethernet cable. See the owner's
manual of "Network Set-up and Operation" for
details.
!1 R/C JACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
y