Dolby 3D System; Lamp Compartment; Anode Yoke - Christie CP4230 Service Manual

®
5.11.6 Dolby 3D System
For information on how to install Dolby
refer to the instruction manual supplied by Dolby
Be aware that in order to install this system the M4
screw located behind the cardcage must be
removed. (Figure 5-51) This screw secures the two
firewalls and must be removed in order to create a
gap for the cable to run to the side break out panel.
To remove the screw, use the 3mm hex driver
provided with the projector.

5.12 Lamp Compartment

5.12.1 Anode Yoke

The anode yoke is located directly in front of the reflector and its position is adjustable depending on the lamp
being installed.
(Estimated Replacement Time: 4 minutes)
1. Open the lamp door. Refer to
2. Remove the lamp (if installed). Refer to
3. Using a 5mm hex key, remove the two screws and lock washers from the yoke base. (Figure 5-52)
CP4230 Service Manual
020-100622-04 Rev. 1 (05-2016)
3D kits,
®
.
®
5.4.8 Lamp Door, on page
5.12.5 Lamp Replacement, on page
Figure 5-52 Front of Lamp Compartment
Section 5: Parts and Module Replacement
Figure 5-51 Remove Screw Behind Cardcage
5-9.
5-38.
5-35