Install/Maintenance - Christie APS Series Service Manual

4. Install/Maintenance

Installing the Batteries
■
Please insert the batteries into the remote control before using it. If the remote control starts to malfunction,
try to replace the batteries. If you will not use the remote control for long period, remove the batteries from
the remote control and store them in a safe place.
Remove the battery cover.
1.
Align and insert the two AA batteries according to their plus and minus
2.
terminals as indicated in the remote control. (Use the appropriate AA
carbon-zinc or alkaline batteries (non-rechargeable) in accordance with
laws and regulations.)
Put the battery cover back to the former state.
3.
WARNING
►Always handle the batteries with care and use them only as directed.
Improper use may result in battery explosion, cracking or leakage, which could result in
fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the specified batteries. Do not use batteries of different types at the
same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not place a battery in a fire or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
■ Replacing the internal clock battery
Installing the battery is required in some cases. A battery is not contained at the time of factory shipment.
Please replace a battery according to the following procedure.
Turn the projector off, and unplug the power cord. Allow the projector to cool sufficiently.
1.
Turn the battery cover fully counterclockwise using a coin or the like, and pick the cover up
2.
to remove it.
Pry up the battery using a flathead screwdriver or the like to take it out. Do not use any
3.
metal tools. While prying it up, put a finger lightly on the battery since it may pop out of the
holder.
Replace the battery with a new MAXELL,
4.
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it into the holder until it clicks.
Replace the battery cover in place, then turn it clockwise to fix by using a coin or the like.
5.
WARNING ►Always handle the batteries with care and use them only as directed.
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
And also improper use may result in cracking or leakage, which could result in fire,
injury and/or pollution of the surrounding environment.
・ Be sure to use only the batteries specified.
・ Make sure the plus and minus terminals are correctly aligned when loading a battery.
・ Keep a battery away from children and pets. If swallowed, consult a physician
immediately for emergency treatment.
・ Do not short circuit or solder a battery.
・ Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry
place.
・ If you observe battery leakage, wipe out the leakage and then replace a battery. If
the leakage adheres to your body or clothes, rinse well with water immediately.
・ Obey the local laws on disposing a battery.
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
7
Battery Cover
90°
90°
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series