Paper Feed From Bypass Tray - Kyocera Mita DC-2560 Service Manual

1AH

(1-2) Paper feed from bypass tray

The bypass tray can hold up to 50 sheets of paper at the one time.
When copying starts, the bypass solenoid (BYPSOL) comes on and the bypass stopper is
released and at the same time, the SB forwarding pulley comes down into contact with the
paper and the paper set on the bypass table is feed to the SB upper paper feed pulley and
the SB lower paper feed pulley.
In this state, the bypass paper feed clutch (BYPCL) comes on, the drive motor (DM) drive
is transmitted to the SB upper paper feed roller and the SB lower paper feed roller and the
primary paper feed starts. The SB lower paper feed roller rotates in the opposite direction
from the paper feed direction and prevents multiple sheets from being feed through the
operation of its one-way clutch.
1 Bypass solenoid (BYPSOL)
2 SB forwarding pulley
3 Bypass stopper
4 Bypass upper guide
5 Bypass paper switch (BYPPSW)
1-3-14
Figure 1-3-12 Bypass paper feed section
5 4
1
2
6
9
8
7
6 SB upper paper feed pulley
7 Bypass lower guide
8 SB lower paper feed pulley
9 Bypass friction plate
0 Bypass tray
3
0